Remote connection via http server

[ALEJANDRO]

If I open a port through the router, could I connect to a logic machine via the WAN IP address?

 Puerto Externo = WAN port
Puerto Interno = LAN port

[Daniel]

To webserver yes, to KNX and BACnet no.

[ALEJANDRO]

What I want is to access the SCADA system, that is, the logic machine, through its static IP address. The problem I've encountered is that the network card I installed in the router doesn't have a static IP address, so the HTTP or HTTPS option won't work.

I'm looking at the VPN option as a zero-tier solution.

[ALEJANDRO]

I don't understand the state "REQUESTING_CONFIGURATION"

[admin]

Have you configured a valid gateway and DNS in Network > Interfaces > eth0?

[ALEJANDRO]

Here you can see

[admin]

Your gateway IP is in another subnet, this setup won't work.

Either the gateway is wrong and should be 192.168.0.1 or LM IP must be in the 192.168.1.x range.

[ALEJANDRO]

You are right, my device's gateway was my router's ip, now i see my LM in zerotier