Yesterday, 08:03
Hi
I'm trying to use the internal DALI-Gateway (2) on a LM5p2-DW1 but it only finds 1-2 ballasts, even though there are many more connected.
My setup is the LM ^, for DALI PSU I use a https://www.lunatone.com/en/product/dali-ps-en/ and the ballasts are simple DALI-drivers over spots.
I updated the firmware for the LM to version 20251204 for the LM5 Lite + Ext version.
Installed the package genohm-scada-dali_20200722 (I have no idea if this even does anything relevant
)
Then did a "Full scan, set short addresses", but only found 1 ballast. What am I doing wrong?
Next up, is there no feedback-object for these ballasts and can I group them or is that done by scripting/writing to multiple ballasts?
Thanks a lot in advance.
I'm trying to use the internal DALI-Gateway (2) on a LM5p2-DW1 but it only finds 1-2 ballasts, even though there are many more connected.
My setup is the LM ^, for DALI PSU I use a https://www.lunatone.com/en/product/dali-ps-en/ and the ballasts are simple DALI-drivers over spots.
I updated the firmware for the LM to version 20251204 for the LM5 Lite + Ext version.
Installed the package genohm-scada-dali_20200722 (I have no idea if this even does anything relevant
)Then did a "Full scan, set short addresses", but only found 1 ballast. What am I doing wrong?
Next up, is there no feedback-object for these ballasts and can I group them or is that done by scripting/writing to multiple ballasts?
Thanks a lot in advance.
