upgrade FW to 2.1.1 (Wiser for KNX)

[Mr.D]

Hi,

Did you check if the SD card is switched to read-only?

Create a new object, reboot and check if the object is still there.

If it’s still there then check the memory load, if it’s not there anymore you need to replace your SD card.

BR,

Erwin

Hi,

Do I need a SD card to upgrade?
I am not using a SD card at the moment... Not that I am aware of anyway.
That has not been needed before...

I have ARM926EJ-S rev 5 (v5l)
HW: spaceLYnk (i.MX28)
so I presume I am on HW1.

System says I have 3G free space and 97 mb (80%) of free memory