This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

upgrade FW to 2.1.1 (Wiser for KNX)
#20
(17.01.2020, 19:36)Erwin van der Zwart Wrote: Hi,

Well first of all it should not happen but the reality is that SD cards are not indestructible.

We changed to SPI flash in HW3+ to reduce the risk of broken SD cards, I think the achilles heel of the controller is now removed.

You could keep using this SD card but that would mean that you cannot change or store any data to the controller anymore, i would not advice to do that, you need to replace it. I would advise to use a industrial quality to extend the lifetime massively.

There is no way to run LM firmware on SL hardware.

BR,

Erwin

Is there a particular SD card you recommend? Also, does the size matter in any way? I am currently only using 1 gb out of the 4 gb that comes standard.
Also, does the read/write speed matter at all?

My "defect" SD card, does this influence performance in any way? Make the SL slower etc?
BR,
Mr.D
Reply


Messages In This Thread
RE: upgrade FW to 2.1.1 (Wiser for KNX) - by Mr.D - 18.01.2020, 16:13

Forum Jump: