This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

USB-Serial Two way communication
#1
Hi all,

I am implementing an ASCII  communication protocol for a Paradox EVO192 security system and i would like to use the USB port of Logic Machine Load Balancer directly connected to Paradox PRT3 Integration Module.

If it is possible could someone advice the best way to have two way communication in order to listen and at the same time send commands to the security system.

Thank you in advance
George
Reply


Forum Jump: