This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Two ports RS-485
#7
Ideally a bus topology should be used. 120 Ohm termination resistors at both ends are required for long lines. If there are branches/stubs, then they must be kept as short as possible. Or use a repeater for long branches, this way you can connect more than 31 devices per line.
Reply


Messages In This Thread
Two ports RS-485 - by Demus - 28.03.2018, 17:31
RE: Two ports RS-485 - by admin - 29.03.2018, 06:04
RE: Two ports RS-485 - by manos@dynamitec - 05.10.2022, 09:55
RE: Two ports RS-485 - by Daniel - 05.10.2022, 10:02
RE: Two ports RS-485 - by manos@dynamitec - 05.10.2022, 12:06
RE: Two ports RS-485 - by Daniel - 05.10.2022, 12:12
RE: Two ports RS-485 - by manos@dynamitec - 05.10.2022, 12:20
RE: Two ports RS-485 - by admin - 05.10.2022, 12:15
RE: Two ports RS-485 - by manos@dynamitec - 05.10.2022, 12:25
RE: Two ports RS-485 - by Daniel - 05.10.2022, 12:22
RE: Two ports RS-485 - by admin - 05.10.2022, 12:24

Forum Jump: