This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

FB event run
#12
Sure you can have 1 timer to trigger all blocks. In this case you will create one resident script which will run every 5 sec. In this case make sure you set delta on output to send values on change of value only. Otherwise you will send every 5s from every block which is not nice to KNX load. You can also un-select 'write to bus' which will not write to TP but only when you can.
It is much better to use event way as then logic is used only when it is needed.
------------------------------
Ctrl+F5
Reply


Messages In This Thread
FB event run - by Kai-Roger - 25.08.2018, 07:34
RE: FB event run - by Erwin van der Zwart - 25.08.2018, 07:51
RE: FB event run - by Kai-Roger - 25.08.2018, 09:35
RE: FB event run - by Erwin van der Zwart - 25.08.2018, 10:24
RE: FB event run - by Kai-Roger - 25.08.2018, 11:14
RE: FB event run - by Daniel - 27.08.2018, 07:39
RE: FB event run - by Kai-Roger - 27.08.2018, 10:23
RE: FB event run - by Daniel - 27.08.2018, 10:55
RE: FB event run - by Kai-Roger - 27.08.2018, 11:28
RE: FB event run - by Daniel - 27.08.2018, 11:36
RE: FB event run - by Kai-Roger - 27.08.2018, 11:41
RE: FB event run - by Daniel - 27.08.2018, 11:58
RE: FB event run - by Kai-Roger - 27.08.2018, 21:08

Forum Jump: