This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Amatiline with logicmachine 5
#1
Hi all,
   I am connection Amatiline with logicmachine 5(LM5). I setup configuration Amatiline with address physical ( 0/5/1,0/5/2... for Volume, play, stop...) and connection with LM5. When i control Amatiline as display Amatiline -> address (0/5/1,0/5/2....) on LM5 feedback but i control from LM5 then address (0/5/1....) no interact on Amatiline.
  Help me please!!!
Thanks!!
Reply
#2
(25.12.2018, 00:44)alphaknx Wrote: Hi all,
   I am connection Amatiline with logicmachine 5(LM5). I setup configuration Amatiline with address physical ( 0/5/1,0/5/2... for Volume, play, stop...) and connection with LM5. When i control Amatiline as display Amatiline -> address (0/5/1,0/5/2....) on LM5 feedback but i control from LM5 then address (0/5/1....) no interact on Amatiline.
  Help me please!!!
Thanks!!

check KNX Physical addess in LM and Amati. it must not be the same.
for example set lm to 15.15.255, amati 15.15.1
Reply


Forum Jump: