This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Modbus: write to bus enable
#1
Hi,
in order to reduce KNX traffic bus I have disable the flag "write to bus" in modbus oject map.

Unfortunately LM is going on to write on bus. What do you suggest?

Thanks.
Reply
#2
You can use Virtual objects but are you sure it is writing? Which fw do you use?
You can also add Value send delta: to limit traffic.
------------------------------
Ctrl+F5
Reply
#3
(15.06.2020, 14:16)Daniel. Wrote: You can use Virtual objects but are you sure it is writing? Which fw do you use?
You can also add Value send delta: to limit traffic.

Hi Daniel,

unfortunately they are not virtual object. But I expect that with that flag trafficis reduced. I would like to avoid to rebuild objects.

Firmware is the last one.

In the meanwhile I change the value send.
Reply
#4
What is latest one? My latest is definitely not the same what yours Smile
RC1?
------------------------------
Ctrl+F5
Reply
#5
You're right.

What I have downloaded from your post dated october 2019 for LM5 lite.

It is called lm5m3-20191015

Thanks.
Reply


Forum Jump: