This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

1-wire pullup resistor
#1
Hi,
Do I need a pullup resistor for 1-wire temperature sensors ds18b20 connected to Re:actor?
Reply
#2
Are you powering it from 5V or using parasitic power? From datasheet: VDD must be grounded for operation in parasite power mode.
Reply
#3
(08.10.2019, 11:07)admin Wrote: Are you powering it from 5V or using parasitic power? From datasheet: VDD must be grounded for operation in parasite power mode.
 3 wires: +5v, GND, Data.
Reply
#4
Pull-up is not needed but you can get more reliable readings by adding a capacitor (at least 0.1uF) between +5V and GND as close as possible to the sensor.
Reply
#5
(08.10.2019, 12:05)admin Wrote: Pull-up is not needed but you can get more reliable readings by adding a capacitor (at least 0.1uF) between +5V and GND as close as possible to the sensor.

Thank you.
Reply


Forum Jump: