This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

LogicMachine KNX IP Routing (UDP)
#7
(16.07.2020, 12:16)Tokatubs Wrote: Weinzler ip routers, and some Zennio and LM5.

Problem is that its separated in two technical ip networks. 172.16.69.xx and 172.16.70.xx.
The LM5 is located on xx.70.xx range and can read fine from all lines.
Problem is i am not able to write to specially the 69.xx segment.
I dont see any problems on the multicast and udp packages.
Multicast TTL is set to 10 for testing.
If your computer is physically connected to 69.xx segment try to sniff with wireshark. Does LM (xx.70.xx) write packages come thru?
I have experiences with IT guys, they tell you all limitations are removed but still some rules apply.

If packages comes thru then there is problem with ip router I think.
Reply


Messages In This Thread
RE: LogicMachine KNX IP Routing (UDP) - by fleeceable - 16.07.2020, 13:25

Forum Jump: