This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

1-wire on LM5lite with DS9490R dongle
#1
Hello,

I would like to integrate 1-wire temperature, lux and humidity sensors into the LM5lite, can You explain how i can do it further? Maybe there is a way of reading values with a script or so?
I really need a quick answer.

Best Regards, 
Robertas Birgiolas’s
Reply
#2
Check that you have 2023 firmware then install libow, owserver, luaow and genohm-scada-w1 packages from here: https://dl.openrb.com/lm-23-imx6/pkg/
Install through System config > System > Packages > Add package (green plus icon).
Reply
#3
(31.10.2023, 07:55)admin Wrote: Check that you have 2023 firmware then install libow, owserver, luaow and genohm-scada-w1 packages from here: https://dl.openrb.com/lm-23-imx6/pkg/
Install through System config > System > Packages > Add package (green plus icon).

Can other adapters be used for 1-wire?
Reply
#4
Only DS9490R is supported over USB.
Reply
#5
I ordered DS9490R, waiting for arival, after recieving it I will test it and tell You the results.

Thanks
Reply


Forum Jump: