07.12.2020, 12:22
Hi,
Type of LM and firmware below:
HW: LM5 Lite (i.MX6)
SW: 20200116
packages:
There's an export of BV from KNX to bacnet and feedbacks coming from BACNET.
Server is enabled, if not Johnson Control BACNET controller doesn't see LM.
We were able to detect LM from Johnson Control's BACNET controller and also exported objects when LM is restarted.
After some minutes Johnson Control's BACNET controller indicates that LM is off line.
Is it possible that LM goes offline because there's no stauts change in the BV?
Type of LM and firmware below:
HW: LM5 Lite (i.MX6)
SW: 20200116
packages:
There's an export of BV from KNX to bacnet and feedbacks coming from BACNET.
Server is enabled, if not Johnson Control BACNET controller doesn't see LM.
We were able to detect LM from Johnson Control's BACNET controller and also exported objects when LM is restarted.
After some minutes Johnson Control's BACNET controller indicates that LM is off line.
Is it possible that LM goes offline because there's no stauts change in the BV?
Gr.
Geert
Geert