Modbus profile generator

[mkaymak]

I created a profile with modbus profile generator,but I'm not sure that i did it correctly would you guys check it for me please ?

Code:

{
  "manufacturer": "YORK",
  "description": "HA-MA164AD",
  "mapping": [
    {
      "name": "Indoor Unit Setpoint Temperature C\u00B0",
      "address": 1,
      "bus_datatype": "uint32",
      "datatype": "uint32",
      "type": "register",
      "units": "A",
      "writable": "true"
    },
    {
      "name": "Indoor Unit Mode Selection",
      "address": 2,
      "bus_datatype": "uint32",
      "datatype": "uint32",
      "type": "register",
      "units": "A",
      "writable": "true"
    },
    {
      "name": "Indoor Unit Fan Speed",
      "address": 3,
      "bus_datatype": "uint32",
      "datatype": "uint32",
      "type": "register",
      "units": "A",
      "writable": "true"
    },
    {
      "name": "Indoor Unit Control Mode",
      "address": 4,
      "bus_datatype": "uint32",
      "datatype": "uint32",
      "type": "register",
      "units": "A",
      "writable": "true"
    },
    {
      "name": "Indoor Unit On/OFF",
      "address": 1,
      "bus_datatype": "bool",
      "datatype": "uint32",
      "type": "coil",
      "units": "A",
      "writable": "true"
    }
  ]
}