This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

Open LM4 device
#1
OK, so I found out I have a read-only SD card (actually two of them).
Now I've had this before and replaced it then, but I completely forgot how I physically changed it Blush 

Do I have to remove the device from the DIN rail? How do I open the device? I can find nothing in the manual on this subject and I don't want to break things...

TIA.
Reply
#2
You need to power it down and take it of the panel. Remove the bottom part and then the PCB. You will find the card there.
Reply
#3
(28.12.2020, 12:32)Daniel. Wrote: You need to power it down and take it of the panel.  Remove the bottom part and then the PCB. You will find the card there.

OK thanks.
Reply


Forum Jump: