Can't program KNX devices via SpaceLynk

[christiaens.t]

Hi
Can you test this patch?
https://dl.openrb.com/lmup/2021.03.17-knx_prog.lmup
Please make sure that you use 2.6.0 before installing it!
BR

Thank you Daniel!

I will try it as as soon as possible.
In the mean time I was able to program a Zennio Square TMD 6 via the W4K as gateway by enabling the 'Use slower bus traffic' for this project in ETS.
This worked after a couple of tries, but it took about 10-15 minutes to program a single device.

Thijs