This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

LM access but not giving Commands to KNX
#1
Hi I have instellad an LM5p2-DR in a new project for the first time and I can access the device with IP I can ping it but when I am pressing for turning ON a light then it doesn't work 
Why? I have connected the KNX (which I mesaured correct ) but I can't access the KNX somehow.
Is it possible to help me please?
Reply
#2
Did you select correct KNX Mode? System-Network-KNX connection. It should be TP-uart.
------------------------------
Ctrl+F5
Reply
#3
(06.04.2021, 08:19)Daniel. Wrote: Did you select correct KNX Mode? System-Network-KNX connection. It should be TP-uart.

Oh yes I had it as IP Tunneling! Thank you very much!
Reply


Forum Jump: