This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Analog Input Reactor
#1
Hello

Should I acquire a signal from a resistive level (fuel) in the REACTOR can I use input 14, using the 5 V generated by the reactor itself, in case of resistance 0 the input is protected or better put a limiting resistor in series?

Thanks so much
Reply
#2
Do you have a datasheet for this sensor?
Reply
#3
(20.05.2021, 16:39)admin Wrote: Do you have a datasheet for this sensor?

I use different types of sensors ranging from 180 to 300 ohms. depending on the manufacturer of the equipment.
Reply


Forum Jump: