This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Logicmachine and Bacnet communication
#1
Hi!

I am using Logicmachine 5 for bacnet communication to a Siemens PXE 50- E.d.

There are several values i am reading/writing on bacnet.

I tried to have one resident script with all the values for ventilation,  and a second resident script for all the values to control the room.(heating, cooling, light++)



I also tried to read values from bacnet with a resident script , and then write values to bacnet with event script....(when knx values updates the event script is triggered).
This didnt work so fine.....

I had the latest backnet package, but removed it and installed and older package that i have on  another LM. (that i know works)


My question is, do i have to have all in the same resident script?

Seems like it collides or something when i have two diffrent script that requires bacnet....or the script runs at the same time....




-S-
Reply
#2
Yes everything must be single resident script.
------------------------------
Ctrl+F5
Reply
#3
Thanks Smile
Reply


Forum Jump: