This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

OVERLOAD TP
#1
Greetings
I have a problem since yesterday without modifying anything, the LM goes into overload

thanks a lot

Greetings
I have a problem since yesterday without modifying anything, the LM goes into overload

thanks a lot


one of image is wrong

Attached Files Thumbnail(s)
               
Reply
#2
Seems you have high bus load. Try to debug why.
------------------------------
Ctrl+F5
Reply
#3
A lot of repeats. Looks like KNX loop.
------------------------------
Ctrl+F5
Reply
#4
(02.12.2021, 08:38)Daniel Wrote: A lot of repeats. Looks like KNX loop.

some idea to find why ?
I have change nothing in programm.
Reply
#5
Connect using ETS and check which device is sending a lot of telegrams
Reply
#6
Usually it happens when there is second IP router connected. I know nothing about your project so hard to say.
Change KNX multicast and see if ti helped
------------------------------
Ctrl+F5
Reply
#7
Actually IP shows 0 so this is probably a script loop or something on KNX side
------------------------------
Ctrl+F5
Reply


Forum Jump: