This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Zwave - Fibaro Motion Sensor
Good time!

I'm testing z-wave.me stick to control wireless devices. And I have a few questions.

1. How to get feedback into a KNX network from a z-wave device? I guess I have to "write to bus", isn't it?
2. What does the "pool interval" (z-wave network settings) parameter mean, and why  I can't change it?
3. Why do I need "pooling" checkbox, and why I can't set it too?

Thanks

Reply
1. Yes
2. How often stick check if device is Alive, Dead, or in Sleep
3. If you have sensor and you want to pool value from it.
------------------------------
Ctrl+F5
Reply
(28.01.2020, 13:51)Daniel. Wrote: 1. Yes
2. How often stick check if device is Alive, Dead, or in Sleep
3. If you have sensor and you want to pool value from it.

Many thanks, Daniel!

1. Can I get feedback to another KNX address?
2. Why does not change the value? (pool interval and pooling checkbox)
Reply
1. What do you mean?
2. Don't know but it is not so important.
------------------------------
Ctrl+F5
Reply
(28.01.2020, 15:13)Daniel. Wrote: 1. What do you mean?
2. Don't know but it is not so important.

Hi!

1. The visualization control has the command send address and the feedback address.
2. In my case, no updates happen at all. For example, if a z-wave device is turned off, its status will change to "dead" only after rebooting LM.

Thanks
Reply


Forum Jump: