This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

[OLD] LogicMachine firmware 2016.09
#26
I get the same error: some objects with address 2/xx/xx are apprearing without reason. This happens after I re-program the firmware on any device connected to KNX using my LM4 hardware. Note that I download the firmware via ETS3 using local LAN and I also have USB commissioning port, but I don't use it for such purpose.

Attached is a screenshot.

Attached Files Thumbnail(s)
   


Messages In This Thread
[RELEASE-CANDIDATE] LogicMachine firmware 2016.09 - by andeug - 25.10.2016, 06:59

Forum Jump: