This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

[OLD] LogicMachine firmware 2016.09
#30
(26.10.2016, 23:44)PassivPluss Wrote: Hi. I Just installer a New Dali driver and the only way I could fint it was to run a full New scan and i had to text/map all existing Dali again. The other options didn't work. The drivers then also changed adresses so I had to blink existing lamps again.Sad

you should set address to new ballast with usb-Dali interface. LM can't set address to one ballast.
then you shoukd use "search only new devices"


Messages In This Thread
RE: [RELEASE-CANDIDATE] LogicMachine firmware 2016.09 - by AEK - 27.10.2016, 09:21

Forum Jump: