This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Problems scanning devices or adding them
Good companions, I hope you are excellent. I have a logic machine LM5 Lite + Ext (i.MX6) with CAN (LM5p2-KC), which I recently updated to the latest current firmware (20211215). The problem I have is that when scanning the CAN line or trying to address some devices, it stays charging or I get the message "Failed to communicate with the device. Make sure that it is powered on and CAN bus is connected". I currently have 2 devices (CAN-R8 and CAN-UIO8-LoRa) connected to the CAN bus, with their respective connection that even blink when I connect them to the bus, but the logic machine CAN App does not recognize them. I have not tried with another logic machine that has CAN, because it is the only one I have. Thank you and I am attentive to your comments.
Please make sure you have latest firmware on the CANx devices
(18.07.2022, 07:15)Daniel Wrote: Please make sure you have latest firmware on the CANx devices

Okay. Thank you very much. I updated the firmwares and they are already working for me. Thank you very much

Forum Jump: