KNX Read Value from other device (KNX TP)

[Habib]

Hi again,

I've asked in another thread how I can prevent sending a value to KNX TP Network from modbus TCP. In this thread I need to read a value from an KNX Objekt which is set in my SL only. I need it to get the current status.

If I try it to read it in ETS (connected with an KNX USB Device) I get no values. The SL Shows no request to that object.

The SL and my USB device are in the same line (SL = 0.0.1, USB Device 0.0.13). If I change the value in SL the ETS (USB) show me that, but Only reading fails.

The Object in SL:
   

The Definition in ETS:
   

The ETS Monitor output:
   

BR
Habib

[Erwin van der Zwart]

Hi Habib,

See this topic to make a object respond on a read request:

http://forum.logicmachine.net/showthread...=read+flag

BR,

Erwin

[Habib]

Hi Erwin,

Thanks for the quick help. That was an easy solution :-)