This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
KNX/TP link scripting

Linear Mode
KNX/TP link scripting
admin Offline
Administrator
Posts: 7331
Threads: 41
Joined: Jun 2015
Reputation: 420
#8
28.03.2017, 09:50
Sleep interval must be set to 0. It will only monitor current bus status events, previous state is not reported in any way. Bus status change is not instant, some small amount of time must pass before disconnect event is reported.
Find
Reply


Messages In This Thread
KNX/TP link scripting - by DarthPaul - 27.03.2017, 13:11
RE: KNX/TP link scripting - by admin - 27.03.2017, 13:49
RE: KNX/TP link scripting - by DarthPaul - 28.03.2017, 05:22
RE: KNX/TP link scripting - by admin - 28.03.2017, 06:00
RE: KNX/TP link scripting - by DarthPaul - 28.03.2017, 06:46
RE: KNX/TP link scripting - by admin - 28.03.2017, 08:31
RE: KNX/TP link scripting - by DarthPaul - 28.03.2017, 09:32
RE: KNX/TP link scripting - by admin - 28.03.2017, 09:50
RE: KNX/TP link scripting - by DarthPaul - 28.03.2017, 10:54
RE: KNX/TP link scripting - by admin - 28.03.2017, 10:57
RE: KNX/TP link scripting - by DarthPaul - 28.03.2017, 11:38

Forum Jump: