31.03.2017, 15:55
hello,
as you see i'am new here and a beginner in knx and i ran into some "problems" with the visusalisation using the homeLynk.
I placed this post earlier on the belgian knx forum but someone recommend me to come to this forum, so i did.
on my "start" page i have a picture frame where i refresh every second a picturestream of a hikvision ip camera, it works almost perfect only when i start my visualisation the stream doesn't always start automatic only after i click in the picture frame and it opens a webbrowser to go to the livestream and i close it back again, this is for a android tablet.
For a Ipad it works just one time and i have to close the visualisation complete and reopen it.
If someone could give me a push in the right direction i would appreciate it verry much .
thanks in advance
as you see i'am new here and a beginner in knx and i ran into some "problems" with the visusalisation using the homeLynk.
I placed this post earlier on the belgian knx forum but someone recommend me to come to this forum, so i did.
on my "start" page i have a picture frame where i refresh every second a picturestream of a hikvision ip camera, it works almost perfect only when i start my visualisation the stream doesn't always start automatic only after i click in the picture frame and it opens a webbrowser to go to the livestream and i close it back again, this is for a android tablet.
For a Ipad it works just one time and i have to close the visualisation complete and reopen it.
If someone could give me a push in the right direction i would appreciate it verry much .
thanks in advance