This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Visualization Crash
#1
Hi,

We have a LogicMachine installed for the visualization of KNX System.

The Logic has been working for some months. 

One month ago we can't connect to LogicMachine WEB but we can connect through ETS and he was sending Telegrams and responding. He had ping.

We need to repair this and we turned off power and then turned on. After the reset we could connect to LogicMachine WEB.

Now the problem is when we enter to visualization mode. There's nothing on the visualization (only background color), but if we go to edit mode there are all the buttons, images, texts...

Thanks for the help!
Reply
#2
Most likely an SD card issue, try replacing it. Recovery procedure is described here:
http://openrb.com/reflash-logicmachine3-...-software/
Reply


Forum Jump: