+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: Announcements (https://forum.logicmachine.net/forumdisplay.php?fid=7)
+--- Forum: Software updates (https://forum.logicmachine.net/forumdisplay.php?fid=13)
+--- Thread: [OLD] LogicMachine firmware 2024.01 (/showthread.php?tid=5219)
Pages:
1
2
RE: [BETA] LogicMachine firmware 2024.01 - admin - 20.02.2024
Are you using KNX/IP secure? Is the communication between LM and KNX routers working correctly?
RE: [BETA] LogicMachine firmware 2024.01 - jlfneira - 20.02.2024
(20.02.2024, 07:53)admin Wrote: Are you using KNX/IP secure? Is the communication between LM and KNX routers working correctly?
Hi. I'm not using knx secure. Yes, LM and routers is working. I can deliver command, but I can't see it in group monitor
RE: [BETA] LogicMachine firmware 2024.01 - admin - 20.02.2024
Which ETS connection mode is used? KNX/IP Routing (multicast) or KNX/IP Tunnel to LM?
RE: [BETA] LogicMachine firmware 2024.01 - jlfneira - 20.02.2024
(20.02.2024, 09:47)admin Wrote: Which ETS connection mode is used? KNX/IP Routing (multicast) or KNX/IP Tunnel to LM?
In knx connection is selected IP routing (multicast to 224.0.23.12). If I'm phisically conected to ip network I can see LM traffic in group monitor using multicast (wifi adaptor). If I connect, locally or VPN, to an IP router (knx tunneling) I only see devices response in GROUP MONITOR, not LM telegrams. If I connect to router and use BUS MONITOR I can see LM telegrams. Kinda strange
RE: [BETA] LogicMachine firmware 2024.01 - jlfneira - 22.02.2024
(20.02.2024, 11:52)jlfneira Wrote:(20.02.2024, 09:47)admin Wrote: Which ETS connection mode is used? KNX/IP Routing (multicast) or KNX/IP Tunnel to LM?
In knx connection is selected IP routing (multicast to 224.0.23.12). If I'm phisically conected to ip network I can see LM traffic in group monitor using multicast (wifi adaptor). If I connect, locally or VPN, to an IP router (knx tunneling) I only see devices response in GROUP MONITOR, not LM telegrams. If I connect to router and use BUS MONITOR I can see LM telegrams. Kinda strange
Sorry for your time. Problem is at knx/ip router. There are three same model (IPR/S 3.5.1 from ABB) and one of them just show this behaviour. Probably an internal error. Telegrams from Logic Machine show fine in another line and KNX/IP and routing from another device (not Logic Machine) neither show in affected gateway. Thank you