+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: KNX Remote connection (/showthread.php?tid=1146)
KNX Remote connection - Krstfr2k - 21.12.2017
Hello, does anyone have any experience with remote connection to the KNX Bus through LM?
I have tried opening port 3671 in my router but I'm not able to access it.
RE: KNX Remote connection - admin - 21.12.2017
Make sure that you open UDP port not TCP. Also, LM must have gateway configured in network/interfaces,
RE: KNX Remote connection - Erwin van der Zwart - 21.12.2017
Hi,
Also make sure to check the "use NAT" option in the ETS connection settings
BR,
Erwin
RE: KNX Remote connection - Krstfr2k - 21.12.2017
I have done all that, check my settings in the picture attachments to see if there's anything I have overlooked...
The external port 599 is directed to the internal port 3671 for my LM's IP address 192.168.1.150
RE: KNX Remote connection - gjniewenhuijse - 21.12.2017
(21.12.2017, 08:51)Krstfr2k Wrote: I have done all that, check my settings in the picture attachments to see if there's anything I have overlooked...
The external port 599 is directed to the internal port 3671 for my LM's IP address 192.168.1.150
I think your lm's ip address is not the same as you wrote above, 192.168.10.150 ~= 192.168.1.150