+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Hardware (https://forum.logicmachine.net/forumdisplay.php?fid=12)
+--- Thread: homelynk img (/showthread.php?tid=1287)
homelynk img - YOUSSEF - 14.03.2018
Hello
am having an issue with my homelynk : it contains an old version of a project i did , and it doesn't save any modification i do once i cut off the power .
i did a factory reset , and a firmware update , always back to the same old version
Anything to do ?? thank youu
RE: homelynk img - admin - 14.03.2018
You need to replace SD card because it probably became read-only.
RE: homelynk img - YOUSSEF - 14.03.2018
(14.03.2018, 09:23)admin Wrote: You need to replace SD card because it probably became read-only.
should i just replace it ? there is any soft or installation to do ??
RE: homelynk img - Daniel - 14.03.2018
(14.03.2018, 10:40)YOUSSEF Wrote:(14.03.2018, 09:23)admin Wrote: You need to replace SD card because it probably became read-only.
should i just replace it ? there is any soft or installation to do ??
yes here
if it is old one then use this recovery firmware
BR
RE: homelynk img - YOUSSEF - 14.03.2018
(14.03.2018, 10:50)Daniel. Wrote:(14.03.2018, 10:40)YOUSSEF Wrote:(14.03.2018, 09:23)admin Wrote: You need to replace SD card because it probably became read-only.
should i just replace it ? there is any soft or installation to do ??
yes here
if it is old one then use this recovery firmware
BR
does the recovery is the same for homelynk ??
RE: homelynk img - Daniel - 14.03.2018
yes it is the same
RE: homelynk img - YOUSSEF - 15.03.2018
(14.03.2018, 17:40)Daniel. Wrote: yes it is the same
well thank you for your support
i had to change the SD card , apparently it's dead