Logic Machine Forum
Datatypes knx - Printable Version

+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: Datatypes knx (/showthread.php?tid=1503)

Datatypes knx - Tokatubs - 26.07.2018

I was wondering if it was possible to either add datatypes or change. For example i want to show hvac 20.102 in Ets,comfort, standby. But there is only support for 05. 1 byte unsigned integer which shows 1,2,3,4..

Any ideas?

RE: Datatypes knx - Erwin van der Zwart - 26.07.2018

Hi,

You can use custom values for that.

BR,

Erwin

RE: Datatypes knx - Tokatubs - 29.07.2018

(26.07.2018, 23:18)Erwin van der Zwart Wrote: Hi,

You can use custom values for that.

BR,

Erwin
Perfect, found it. But is it possible to make mass editions, or is it just one and one. Which makes alot of work.. To write this every time. 

Thanks for reply Erwin..

RE: Datatypes knx - AEK - 30.07.2018

(29.07.2018, 22:00)Tokatubs Wrote:
(26.07.2018, 23:18)Erwin van der Zwart Wrote: Hi,

You can use custom values for that.

BR,

Erwin
Perfect, found it. But is it possible to make mass editions, or is it just one and one. Which makes alot of work.. To write this every time. 

Thanks for reply Erwin..
on left side of object tab filter all needed GA (1/1/1,1/1/2,1/2/* etc.) then press Mass edit button on bottom of page, then select custom values