+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Visualization (https://forum.logicmachine.net/forumdisplay.php?fid=9)
+--- Thread: Automatic triggering in KNX bus (/showthread.php?tid=192)
Automatic triggering in KNX bus - s.prathmesh - 14.01.2016
Using LM4 here, done integration and programming with KNX bus. But, when using from touch visualisation; at first time difference between triggering of events and clicking the action were 15-20 seconds . Then, one of the light circuit started automatically with 100% and 20% sometimes; which was then stuck into infinite loop until KNX TP was removed from LM4. What could be the issue here?
RE: Automatic triggering in KNX bus - admin - 14.01.2016
Check that you don't have scripts which are causing infinite loops. Do you have any other KNX/IP routers/gateways connected to the same KNX/TP line as your LM4?
RE: Automatic triggering in KNX bus - s.prathmesh - 14.01.2016
No scripts.
But other KNX/IP router was connected to same KNX/TP line. After disconnecting it, touch visualisation was smooth.
Thank you.
RE: Automatic triggering in KNX bus - s.prathmesh - 18.01.2016
How KNX can be connected to LM-Ambient?
As it works as KNX/IP router, so how it communicates with KNX TP lines?
RE: Automatic triggering in KNX bus - admin - 18.01.2016
You can use any KNX/TP router/gateway or LM4. For gateway you can set Ambient to connect to it via tunneling, otherwise it will use routing and should work without any extra configuration.