+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: CANx (/showthread.php?tid=2411)
CANx - Daponte - 03.01.2020
Hi
I am trying to communicate with 3 CANx devices and I am unable after having done a reset, what can it be?
RE: CANx - Daniel - 03.01.2020
I'm not sure in what state you left them. The easiest is to make new re-flash of firmware.
See this
https://forum.logicmachine.net/showthread.php?tid=2056&pid=12795#pid12795
RE: CANx - Daponte - 03.01.2020
(03.01.2020, 09:31)Daniel. Wrote: I'm not sure in what state you left them. The easiest is to make new re-flash of firmware.THANK YOU, VERY MUCH!
See this
https://forum.logicmachine.net/showthread.php?tid=2056&pid=12795#pid12795
RE: CANx - Silvernail - 10.01.2020
(03.01.2020, 10:51)Daponte Wrote:(03.01.2020, 09:31)Daniel. Wrote: I'm really interested in these mini excavators and not sure in what state you left them. The easiest is to make new re-flash of firmware.THANK YOU, VERY MUCH!
See this
https://forum.logicmachine.net/showthread.php?tid=2056&pid=12795#pid12795
Is there any danger of bricking them when you're doing a firmware update?
RE: CANx - Daniel - 10.01.2020
I did it lots of time and no problem up to now.
RE: CANx - admin - 10.01.2020
Not for CANx devices. USB flashing works even when device does not have any firmware flashed yet.