This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

CANx
#1
Hi
I am trying to communicate with 3 CANx devices and I am unable after having done a reset, what can it be?
Reply
#2
I'm not sure in what state you left them. The easiest is to make new re-flash of firmware.
See this
https://forum.logicmachine.net/showthrea...5#pid12795
Reply
#3
(03.01.2020, 09:31)Daniel. Wrote: I'm not sure in what state you left them. The easiest is to make new re-flash of firmware.
See this
https://forum.logicmachine.net/showthrea...5#pid12795
THANK YOU, VERY MUCH!
Reply
#4
Is there any danger of bricking them when you're doing a firmware update?
Reply
#5
I did it lots of time and no problem up to now.
Reply
#6
Not for CANx devices. USB flashing works even when device does not have any firmware flashed yet.
Reply


Forum Jump: