Logic Machine Forum
[Solved] SpaceLYnk not booting - Printable Version

+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Hardware (https://forum.logicmachine.net/forumdisplay.php?fid=12)
+--- Thread: [Solved] SpaceLYnk not booting (/showthread.php?tid=2719)

[Solved] SpaceLYnk not booting - jjaa - 11.07.2020

Hi,

I was doing a factory reset to my spacelynk due to a major change in my project (and honestly, I couldn't remember the password after being away due to Covid) but it didn't worked
.
Then I discovered that I could no longer communicate with it, although it was discoverable in my network (it kept the same address that was different from the factory one). 

I have used Schneider's "AN103_How to fix issue with bootloader" instructions but it just does not work at all.
Is just makes the green led pulse in oposition to a red one on its inside.

Can someone help, please?

Thank you,
Julio

RE: SpaceLYnk not booting - Daniel - 13.07.2020

Please describe status of both LEDs

RE: SpaceLYnk not booting - jjaa - 13.07.2020

(13.07.2020, 07:24)Daniel. Wrote: Please describe status of both LEDs
Hi Daniel,

With original image file, interior LED is off and exterior LEDs have normal operation, flashing like they usually did. But I cannot communicate with it, although it is discoverable with Advanced IP Scanner.

After installing rec2.img from Schneider's bootloader fix:
LED 2 is off
LED 1 flashes twice, repeatedly  (like a heartbeat)
LED in the interior (color red) flashes opposite to LED1.

The problem may be with the SD Card, but then, it shouldn't allow to save a new image, correct?

Thanks for your help.

RE: SpaceLYnk not booting - Daniel - 13.07.2020

I would recommend you to flash the card. SE has AN for this too.

RE: SpaceLYnk not booting - Erwin van der Zwart - 13.07.2020

Hi,

This is normal behaviour, rec2.img is only booting the device (without having a FW version), after that you are forced to upgrade to the desired FW.

I think you need to clear your browser cache to get the FW upgrade prompt..

BR,

Erwin

RE: SpaceLYnk not booting - jjaa - 14.07.2020

Hi Erwin, 

Thank you for your help. 
The device is now up and running like a charm! Wink 

BR 
Julio