+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: LM not see old KNX sensors (/showthread.php?tid=3876)
LM not see old KNX sensors - ikhy - 15.02.2022
Hi!
We have old WindowsMaster controllers with connected KNX equipment. The connected LM sees only sensors of a certain type (WET112), the rest of the equipment does not see and does not update. LM version 20200727.
Help me please. I have no more ideas.
RE: LM not see old KNX sensors - Daniel - 15.02.2022
What do you mean by does not see? Do not receive KNX telegrams?
RE: LM not see old KNX sensors - ikhy - 15.02.2022
yes, not receive
RE: LM not see old KNX sensors - Dré - 15.02.2022
It only does not work from LM to KNX equipment?
Does ETS telegrams work well?
It is connected by IP?
RE: LM not see old KNX sensors - ikhy - 15.02.2022
Yes, only LM does not receive telegrams, old controllers work. We have 3 lines in 1.1.0, 1.2.0, 1.3.0. The sensors that the LM sees are from lines 1 and 2. The LM is connected via IP, on the same network as the router and old controllers, multicast IP. It doesn't matter what mode is selected TP-UART / EIBnet IP Tunneling / EIBnet IP Routing - the LM receives telegrams only from these sensors.
This is so strange, could there be a problem with the LM version? Or are filters installed somewhere?
sorry for my bad English
RE: LM not see old KNX sensors - CristianAgata - 15.02.2022
Is LM in the line 3?
RE: LM not see old KNX sensors - ikhy - 15.02.2022
No, this 1-3 lines only for old equipment. We want to use LM as a gateway and connect via IP. My question is, could this be related to the LM version?
RE: LM not see old KNX sensors - CristianAgata - 15.02.2022
(15.02.2022, 20:20)ikhy Wrote: No, this 1-3 lines only for old equipment. We want to use LM as a gateway and connect via IP. My question is, could this be related to the LM version?
I don't think, I guess it is a filter table not correct.
BR Cristian
RE: LM not see old KNX sensors - Daniel - 16.02.2022
For LM KNX telegram is a telegram, it does not matter where it came from. Check filter table, src policy.
If KNX would be broken then everything would not work, not just a particular device.