+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Hardware (https://forum.logicmachine.net/forumdisplay.php?fid=12)
+--- Thread: Reactor and power relè card (/showthread.php?tid=4671)
Reactor and power relè card - gdimaria - 23.03.2023
Hi,
I wanted to try using Reactor to drive a 4-input power relay board (5 volt powered) as in the attached pictures.
I think I did everything correctly, but it doesn't work: the leds on the board go on and off, but relays dosn't act.
The same board, however, connected to Arduino board works perfectly.
Can you help me?
Thank you
RE: Reactor and power relè card - Daniel - 23.03.2023
Why did you connect it to 1wire and only partially?
RE: Reactor and power relè card - gdimaria - 23.03.2023
(23.03.2023, 15:15)Daniel Wrote: Why did you connect it to 1wire and only partially?
Actually, as you can see, I connected 5 volts, not 1 wire
RE: Reactor and power relè card - admin - 23.03.2023
This won't work - these relays are meant for 5V operation, LM outputs 24V. Just use normal 24V relays instead.
RE: Reactor and power relè card - gdimaria - 23.03.2023
(23.03.2023, 15:20)admin Wrote: This won't work - these relays are meant for 5V operation, LM outputs 24V. Just use normal 24V relays instead.
OK, thank you!
Peppe