+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: lm reactor raz (/showthread.php?tid=584)
lm reactor raz - 69jtdti - 30.01.2017
hello,
since firmware 20160927, i have a lot of script and visualisation. I want to raz all but :
- when i set reset factory... nothing is erased
- when i restore my backup nothing doing... my trends, names of objects... are no loaded
i'll probably make a mistake...
RE: lm reactor raz - admin - 31.01.2017
Looks like an SD card issue - it became read-only due to an internal failure. You should replace it with a new one and follow these instructions: http://openrb.com/reflash-logicmachine3-and-streaming-player-software/
RE: lm reactor raz - 69jtdti - 31.01.2017
(31.01.2017, 07:32)admin Wrote: Looks like an SD card issue - it became read-only due to an internal failure. You should replace it with a new one and follow these instructions: http://openrb.com/reflash-logicmachine3-and-streaming-player-software/
ok, LM reator has a micro Sd i'll carry out and replace by another or i'll use an USB adapeter to do this?
RE: lm reactor raz - admin - 31.01.2017
You need to install recovery firmware to the new MicroSD card from your PC before replacing it in LM.
RE: lm reactor raz - 69jtdti - 31.01.2017
(31.01.2017, 12:35)admin Wrote: You need to install recovery firmware to the new MicroSD card from your PC before replacing it in LM.
where's the SD card in the Logic Machine reactor? there's only usb port, and IP network.
The owner manual write that there's a reboot switch to restore factory...
I've test it LM reboot but nothing else
RE: lm reactor raz - Erwin van der Zwart - 31.01.2017
Hi,
The SD card is internal on the board, you have to open the device to reach it.
Reset button to factory settings, you have to press it 10 seconds (you see the LED red), release and press direct again for 10 sec (you see LED red flash), release again and press direct again and press 10 seconds. The device will reboot after a small period, just be patience...
However as admin say's SD is in read only mode, the reset will probably not work...
BR,
Erwin
RE: lm reactor raz - 69jtdti - 31.01.2017
(31.01.2017, 20:12)Erwin van der Zwart Wrote: Hi,
The SD card is internal on the board, you have to open the device to reach it.
Reset button to factory settings, you have to press it 10 seconds (you see the LED red), release and press direct again for 10 sec (you see LED red flash), release again and press direct again and press 10 seconds. The device will reboot after a small period, just be patience...
However as admin say's SD is in read only mode, the reset will probably not work...
BR,
Erwin
thanks... yes reset not work.
ok for opening, bad news, i'll unplug all IO wires.
not very easy, on LM reactor wire connectors are not very very good quality after unplugged
RE: lm reactor raz - 69jtdti - 04.02.2017
I have done the recovery reset with new sd card, then flashing firmware...
that's OK for few Hours... then LM reactor become antother time not joignable. IP no responding