+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: General (https://forum.logicmachine.net/forumdisplay.php?fid=2)
+--- Thread: Spacelynk knx communication stops (/showthread.php?tid=813)
Spacelynk knx communication stops - Tokatubs - 29.05.2017
Hello i am using LM for some years, and are happy with it.. Now i got to test an Spacelynk from Schneider.
But it stops just after a couple of hours. As you can see on the connected picture it peaks on 100 %. Everything works normal, but the knx communication stops and nothing goes on out or in of the Spacelynk and nothing goes out on the Ets group monitor.
If i disconnect the knx line and wait a moment and then connect back on, the Spacelynk will start again.
Really annoying. I have just updated the firmware and still the same behavier.
Anybody know anything about this..
RE: Spacelynk knx communication stops - Erwin van der Zwart - 29.05.2017
Hi,
What HW version do you have? What brand KNX powersupply do you use?
Is the bus voltage more then 30V?
BR,
Erwin
RE: Spacelynk knx communication stops - Tokatubs - 29.05.2017
The firmware is 2.0.0.
And i am using an Zennio Zps640Hic230.
http://zennio.com/products/system/zps640hic230
I measured it to under 30.
Thanks for responding..
RE: Spacelynk knx communication stops - Erwin van der Zwart - 29.05.2017
Hi,
What is the hardware version?
Do you use the 24V power outlet from the KNX power supply for the spaceLYnk?
BR,
Erwin
RE: Spacelynk knx communication stops - Tokatubs - 31.05.2017
(29.05.2017, 22:28)Erwin van der Zwart Wrote: Hi,My powersupply is the reg/24v dc/0,4A Mtn693003.
What is the hardware version?
Do you use the 24V power outlet from the KNX power supply for the spaceLYnk?
BR,
Erwin
So it is not supplied via the knx line.
Not sure of the hardware version.
On the side it only says LSS100200
Version V1.1
RN-2014-W38-264
RE: Spacelynk knx communication stops - Erwin van der Zwart - 31.05.2017
Hi,
I think you have a older device with TPUART2, there are some cases known that under certain conditions the TPUART is going to sleep mode. We use different TPUART now.
I think you have one of that devices..
Contact your country's front office to discuss replacement.
BR,
Erwin
RE: Spacelynk knx communication stops - Tokatubs - 31.05.2017
Will do then. Thanks alot for the help..