Logic Machine Forum
LogicMachine3 Re:actor 24 V Output not working - Printable Version

+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Hardware (https://forum.logicmachine.net/forumdisplay.php?fid=12)
+--- Thread: LogicMachine3 Re:actor 24 V Output not working (/showthread.php?tid=946)

LogicMachine3 Re:actor 24 V Output not working - vesa.holtta@aalto.fi - 17.08.2017

Hi,

I have the LogicMachine3 Re:actor and was trying to start using the digital outputs to control some relays. However, I am not able to measure a voltage between any of the digital outputs and 24 V Output ground. There is no voltage in the 24 V Ouput, either.

Any thoughts? Is there a hardware malfunction in my unit? What should I check?

Best regards,
Vesa

RE: LogicMachine3 Re:actor 24 V Output not working - nhieulk - 17.08.2017

Hi,

In LM3:Reactor have 2 pin power supply. Did you supply power for them?

Thanks
Big Grin

RE: LogicMachine3 Re:actor 24 V Output not working - vesa.holtta@aalto.fi - 17.08.2017

(17.08.2017, 09:10)nhieulk Wrote: Hi,

In LM3:Reactor have 2 pin power supply. Did you supply power for them?

Thanks
Big Grin


I was using this wiring diagram from the manual:

   

where there is the label 24 V Output below the red and black connectors on the top left. Now it seems to me that I should actually connect these to the power supply to have it supply power to the digital outputs.

RE: LogicMachine3 Re:actor 24 V Output not working - vesa.holtta@aalto.fi - 17.08.2017

(17.08.2017, 10:19)vesa.holtta@aalto.fi Wrote:
(17.08.2017, 09:10)nhieulk Wrote: Hi,

In LM3:Reactor have 2 pin power supply. Did you supply power for them?

Thanks
Big Grin


I was using this wiring diagram from the manual:



where there is the label 24 V Output below the red and black connectors on the top left. Now it seems to me that I should actually connect these to the power supply to have it supply power to the digital outputs.

This did not solve the problem. There is no voltage in the outputs even though I can see from the web interface that the outputs are on.

Vesa

RE: LogicMachine3 Re:actor 24 V Output not working - morak - 22.08.2017

Hi
Are you sure that you have correct firmware ?

BR

RE: LogicMachine3 Re:actor 24 V Output not working - vesa.holtta@aalto.fi - 22.08.2017

(22.08.2017, 08:19)morak Wrote: Hi
Are you sure that you have correct firmware ?

BR

The firmware was incorrect. Now it works perfectly.

Thank you.

BR,
Vesa