remote knx

[balatis]

hello.
i would like to learn how is possible to do Remote KNX bus control and KNX device reprogramming
i use doname i have not static ip.
thanks 

[admin]

You need to forward UDP port 3671 on your router and use NAT mode in ETS. But from a security point of view it's much better to use VPN.

[balatis]

thanks for the answer .i have a problem with telegram. some times send a local telegram my homelynk on it's own as a result to start a/c ,open some lights
have you any ideas why? in the source address write local
thank you ....

[Daniel]

It can't send on its own. Disable all your scripts, sync, reboot and check again. Also check scheduler.