RTU3 Problem

[Daponte]

Con la última actualización el puerto COM 3-RS485 ha dejado de funcionar, en el puerto 1 y 2 tengo instalado un EKEY y funcionan correctamente, cuando trato de habilitar RTU3, el puerto de comunicación 1 y 2 dejan de funcionar y RTU3 no lo permite estar habilitado , esto ha sido desde la última actualización de firmware, si hago un reinicio en la máquina lógica, los puertos 1 y 2 vuelven a funcionar correctamente, el puerto 3 nunca lo hace, ¿hay alguna solución?

[Daniel]

What is the exact HW do you have? Check the label on the side of LM.

[Daponte]

LM5p2-KC

[Daniel]

What does it say in System Config-System-Upgrade Firmware?

[Daponte]

HW: LM5 Lite (i.MX6)
SW: 20230124

[Daniel]

Then you used wrong firmware. As admin already said use LM5 Lite + Ext (4 or 6 DIN units)

[Daponte]

Entonces usaste un firmware incorrecto. Como ya dijo el administrador, use LM5 Lite + Ext (4 o 6 unidades DIN)

[archivo adjunto=3047]

I'm using that firmware, isn't it correct? which one should i use?

[Daniel]

You must have selected wrong file during installation. Download it again and make sure to select correct file.

[Daniel]

wait, this version might have a bug. Let us check it.

[Daponte]

I have reinstalled the firmware and the same error appears, I have released the connections, com 1 and 2 are perfect, com 3 gives an error, can you connect to my device and see what can happen?

[Daniel]

it is a bug, wait for new fw.

[Daponte]

OK, Thanks very much.