Knx device pinging

[ckabhinanduae]

Hello,
One of my project, i want to ping around 400 knx devices using LM and send that results  to group address. So total 400 individual address and 400 group address.
I want to use this group address for visulization. Anyone can help me to make a scrip for this pinging process?
I dont know maximum how much device can ping without cpu overload.
Thanks

[Daniel]

See this for some examples, ping takes a bit of time and bus bandwidth the 400 is a lot.
https://forum.logicmachine.net/showthrea...7#pid22677

[admin]

Keep in mind that with current firmware you can only ping devices connected directly to LM KNX/TP but not over IP.

[ckabhinanduae]

See this for some examples, ping takes a bit of time and bus bandwidth the 400 is a lot. 
https://forum.logicmachine.net/showthrea...7#pid22677

Thanks for your reply.
I will try this

[ckabhinanduae]

Keep in mind that with current firmware you can only ping devices connected directly to LM KNX/TP but not over IP.

One more help please!!
I have set of group address. If any of that group address receive logic 1, i need to write logic 1 or 0 to a group address. Can anyone tell me how to do this?

[admin]

See this: https://forum.logicmachine.net/showthrea...18#pid1518