i cannot import knxproj to LM

[Simuzer]

hi all,

i have LM5
its seems

I import the project. It says new objects have been added. But when I look at the objects, I cannot see the newly added ones. When I try to add them manually, it does not add them either. 

Firmwaer 20240426

Total objects 4716

i tried import KNXPROJ file,  Import ESF file and run scripting.. But no new objects in list.

[Daniel]

Read the options while importing knxproj. If you want existing objects to be updated you must select this option.

[Simuzer]

i know.

forexample;

1)
by Import file;
23/0/1
...
23/0/200

2) Add Object manually
23/0/1

No error, no fault. everyting is ok. But, there is no 23/0/1 on listing object page.

Reboot.. cut off the energy..
Address 23/0/1 is not showing up. It does not appear in the list.

   

   

[Daniel]

How old is the LM? It looks like you have faulty SD card with read only mode, this is very old issue. You will need to replace the SD card and flash it.
https://kb.logicmachine.net/misc/reflash...ng-player/

[Simuzer]

i have two LM..

I noticed that one of the devices was an SN model.

LM5Lp2 and LM5Lp2SN

I took a backup from LM5Lp2 and loaded the backup into LM5Lp2SN. Total object over of 5.000 object. And no problem. LM5Lp2SN runs by over 5.000 object. But, new objects are not added by manually or import knxproj file. (i think its bug) But i can change page. Its run. No problem.

I took a backup from LM5Lp2SN (with 5000 objects) and loaded the backup into LM5Lp2.

But, in LM5Lp2 , new objects are not added by manually or import knxproj file.

How to fix backup file ?

[admin]

SN model is limited to 3500 objects.