http string commands to LM

[Domoticatorino]

Hi there,
I have some problem to send http commands to LM. The string is the following and obviously I enable remote service:

http://remote:password@ip-address/scada-remote?m=json&r=grp&fn=write&alias=0/0/54&value=true (to control 0/0/54).

If I test it on a web browser sometime works and sometime LM login page appears without send command. Hence I cannot understand what is the difference.

I try to send the http from an external device which it working properly for other HTTP strings but I cannot send string to LM.

What do you suggest to check?

Thanks.

Regards.

[admin]

Do you have "Send Basic auth header" enabled in Remote services settings? If not then enable and try again.

[Domoticatorino]

Do you have "Send Basic auth header" enabled in Remote services settings? If not then enable and try again.

I do it and I try again later on. I keep you informed.

In the meanwhile I have seen on web browser that web response is simply "true" and not OK 200. Is it normal?

Thanks.

BR

[admin]

"true" is what grp.write() returns when the write succeeded. "200 OK" is the first response header which is not shown by the browser.