This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

KNX programming issues
#1
I have a Reactor V3 which was installed on a test bed about a year ago and has been and has been functioning as part of the that system fine.
I decided to complete some changes to my KNX program when I downloaded them via ETS I received a error "State must be open wait""not open idle"
Logging onto the logic machines web interface has been intermittent at best ,
When I get on the System page a pop up keepsĀ appearing "Device not responding" while this is up the drop down menus don't work
the pop disappears after a few minutes

Any suggestions would be appreciated
Reply
#2
Maybe you have an IP conflict in the network?
Reply
#3
That helped thanks, yes there was a conflict
Reply


Forum Jump: