This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
Unused Processes

Threaded Mode
Unused Processes
rocfusion Offline
Member
Posts: 200
Threads: 60
Joined: Jun 2015
Reputation: 7
#1
16.04.2018, 05:59 (This post was last modified: 16.04.2018, 06:18 by rocfusion.)
Hi,

In a typical installation,  I won't be using the Dali, 1-wire, bacnet and modbus parts of the LM.  Is there a way to remove \ disable these components and make this permanent?   The reason I ask because I saw with the Processes app that these modules were using a combined CPU usage of 10%.  Surely  the LM would be more efficient if we could eliminate this overhead.

Thanks,

Roger
Website Find
Reply
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#2
16.04.2018, 06:30
You can uninstall genohm-scada-dali and similar packages from System config > System > Packages. Keep in mind that firmware upgrade will revert them back.
Find
Reply
rocfusion Offline
Member
Posts: 200
Threads: 60
Joined: Jun 2015
Reputation: 7
#3
16.04.2018, 17:40
(16.04.2018, 06:30)admin Wrote: You can uninstall genohm-scada-dali and similar packages from System config > System > Packages. Keep in mind that firmware upgrade will revert them back.

Thank you,  works good.
Website Find
Reply


Forum Jump: