BacNetIP - issues

[Re-G]

Hi. 

I have problem witch BacNet IP client (app). We have to integrate an AHU made by Svegon (GOLD).
Application found a device but if i start looking for data points i have as a result those scenario:

• application after a few seconds found no data points at all;
  
• application keep looking for data points and keep looking, and .... - keep looking endlessly;
  
• if i application found data points:
  - can't add (mapping) points as virtual one - crossed out symbol of cloud;- i can't remove already mapped points as virtual one - i have massage - the point no is not existing on this no. of device (BACNET address)- if i can add points - adding points take ages, and can be only not virtual one.

I tried:

• remove app, and reinstall app again - app after new installation found BacNet device - but data points are already mapped - that same behavior of LM5 with adding points;
  
• factory reset of LM5 - installation of app - app after new installation found BacNet device - but data points are already mapped - that same behavior of LM5 with adding points.
  

I tried web browsers: Chrome, Firefox, Safari.
I tried on LM firmware 2022 RC1, 2022 RC1 and with this one https://dl.openrb.com/lm-22-imx6/lm5m3ex-20221205.img
also witch 20211215.

Any ideas what's going on?

Thanks for help.

[Daniel]

This app has its known limitation. It works on very small installations. You better try our original solution
https://openrb.com/logicmachine-as-bacnet-client/
Uninstall the app if you going to use this.

[Re-G]

This app has its known limitation. It works on very small installations.  You better try our original solution
https://openrb.com/logicmachine-as-bacnet-client/
Uninstall the app if you going to use this.

Thanks for quick answer. But i can't.

This is LM5 Lite.

[Daniel]

Install the genohm-scada-bacnet.ipk from Extra packages in: Sys Config –> System –> Packages

If you use RC1 22 then take packages from here https://dl.openrb.com/lm-22-imx6/pkg/

[Re-G]

Install the genohm-scada-bacnet.ipk from Extra packages in: Sys Config –> System –> Packages

If you use RC1 22 then take packages from here https://dl.openrb.com/lm-22-imx6/pkg/

Thanks.

I did it. Scaning is working well. could you be so polite and tell me how add Bagnet data points to objects?

Thanks again.

[Daniel]

You have to use script for this, there are examples in the link I sent you.

[Re-G]

You  have to use script for this, there are examples in the link I sent you.

Thanks.