This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Visualization v
KNX insert object

Threaded Mode
KNX insert object
Kapetanidis Panagiotis Offline
Junior Member
Posts: 10
Threads: 6
Joined: Mar 2018
Reputation: 0
#1
21.03.2018, 10:49 (This post was last modified: 21.03.2018, 10:51 by Kapetanidis Panagiotis.)
hello,

If i had more than one object in the same group address, how to can insert all objects?

it does not allow me to insert two or more times the same group address.

Thank you
Find
Reply
Erwin van der Zwart Offline
Senior Member
Posts: 1764
Threads: 6
Joined: Jul 2015
Reputation: 117
#2
21.03.2018, 10:58 (This post was last modified: 21.03.2018, 10:58 by Erwin van der Zwart.)
Hi,

A group address is only needed once, if you have multiple objects that needs to listen to a command you need to configure it like that in the ETS.

This is how KNX works and cannot be done another way..

BR,

Erwin
Find
Reply
Thomas Offline
Senior Member
Posts: 411
Threads: 103
Joined: Oct 2016
Reputation: 9
#3
03.04.2018, 12:33
Hi
Maybe related question. Is there a NATting KNX device? Does it exist? Imagine situation you have two KNX network. You can't change group addressing but you want to controll them from one point. Do you know a line coupler able to translate main group address (in 3 numbers addressing scheme) up to 16?
I don't need it. I just got curious when I read the question.
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259
Find
Reply


Forum Jump: